User Rating: 0 / 5

Details

Category: Projects/DIY

Published: Thursday, 02 April 2015 22:16

SETTING THE VOLTAGE

Now get your turntable, remove the slipmat, remove the headshell, remove the counter weight. 

Next you want to remove the platter. You can pull up on either side of the platter from the large open holes to lift it out. It takes a bit of rocking up and down to get it to lift out. If you still have trouble lifting it out, tap the center of the spindle with the handle of a hammer, handle of a screw driver, block of wood. After tapping a few times, try and lift out again.

When you have the platter removed you should see this.

Remove all the screws surrounding this black plastic cover (Officially known as the PCB Cover) but do not remove yet!

Now here is the voltage selector. If you are converting an EU turntable to US, you need to switch this voltage switch to 110.

USA = 110

EU = 220

If your turntable has already been used in the US, and you have a plug like this: 

Your voltage is already set properly at 110v